User's Manual

BLE - DATA TRANSFER
PROBLEM CAUSE SOLUTION
Barcode data is not transferred. Scanner is not connected to the
end device.
1. Scan the pairing barcode.
2. Lights up blue twice briefly while scanner is
connecting and after a successful connection.
Scanner lights up green after the
data transfer, but no barcode data
is shown on the end device.
Scanneris out of range of the end
device.
(Maximum range is < 33 ft. (10m))
Bring scanner closer to the end device and
scan the pairing barcode.
Scanner flashes red 3 times, 3
negative beeps are heard and a
long vibration is felt.
Scanner cannot connect with the
end device.
1. Check whether the range between scanner
and end device is < 33 ft. (10m) If not, get
closer.
2. Disconnect the connection between the end
device and scanner and reconnect
“Step 6: Disconnect scanner” and “Step 4:
Connect scanner”
3. Scan the pairing barcode again.
4. Scan barcode again.