User's Manual

To configure the Gateway / Firmware update:
1. Connect the Gateway with the
computer. The Gateway boots
up. This takes about 2 min and
is finished when the USB LED
shows constant green light.
2. Scan the Pairing Barcode on
the Gateway.
3. Scan this barocde to enable
the Gateway as a mass storage
device on the computer.
NOTE
The configuration will be applied to the scanner and the
Gateway directly.
Scanners, that get connected to the Gateway later will
receive the same configuration!
4. Copy the downloaded configuration
file or the firmware file into the mass
storage device Gateway.
The upload of the configuration takes
about 5 seconds/the upload of the
firmware takes about 2 minutes and
is finished when the USB LED shows
constant green light. The Gateway is
now configurated/updated and can be
connected to the scanner.
5. Scan this barcode to disable the
Gateway as a mass storage device on
the computer.
CAUTION
Do not disconnect the Gateway from the computer during
the upload!
RESULT