User`s manual

ASSEMBLY

Assembly requires two persons. Place all parts of the recumbent cycle in a cleared area and remove the pack-

ing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included

&?........... .

tools, assembly requires an adjustable wrench _ and a Phillips screwdriver (

Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below

each drawing refers to the key number of the part, from the PART LIST on page 14. The second number refers

to the quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping. If a

part is not in the parts bag, check to see if it has been pre-attached.

M8 Flat

Washer (18)-12

M8 Curved M8 Nylon M8 Nylon

Washer (28)-8 Locknut (56)-4 Locknut (35)-4

M6 x 25mm

Hex Screw (29)-4

M6 x 38mm

Hex Screw (67)-4

M8 x 15mm

Button Screw (27)-12

M8 x 20mm

Button Screw (31)=4

M4 x 16mm

Screw (54)--4

M4 x 8mm

Ground Screw (63)-1 M8 x 70mm Carriage Bolt (66)-4

Identify the Front Stabilizer (2), which is shorter than

the Rear Stabilizer (not shown). Attach the Front

Stabilizer to the front of the Frame (1) with two M8 x

70mm Carriage Bolts (66), two M8 Curved Washers

(28), and two M8 Acorn Nuts (56).