User's Manual

HOW TO ADJUST THE DRIVE BELT

If the pedals slip while you are pedaling, even while

the resistance is adjusted to the highest level, the drive

belt may need to be adjusted.

To adjust the drive belt, first press the power switch

to the off position and unplug the power cord.

Next, use

a standard

screwdriver to pry

off the Shield Cover

(75) and the Shield

Cover Cap (118).

See assembly step 15 on page 14. Remove

the Right Upper Body Leg Outer and Inner Covers

(69, 83).

See assembly step 12 on page 12. Remove the

Right Pedal Arm (58) from the Right Upper Body

Leg (60).

Next, remove the M8 x 16mm Screw (95), the Large

Axle Cover (53), and the M8 Washer (not shown) from

the right Crank Arm (20). Then, carefully remove the

Right Pedal Arm (58) and the Right Roller Arm (59)

from the elliptical.

See EXPLODED DRAWING C on page 35.

Identify the Left and Right Shields (73, 74). Remove

the M4 x 19mm Screws (5), the M4 x 25mm Screws

(139), and the M4 x 48mm Screw (107) from the Left

and Right Shields; make sure to note the location of

each size of Screw. Then, remove the Right Shield.

Next, locate and loosen the Idler Screw (89). Tighten

the Belt Adjustment Screw (91) until the Drive Belt

(113) is tight. Then, retighten the Idler Screw.

Reattach the parts that you removed. Then, plug in the

power cord.

118

113