User Manual

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted. To adjust the reed

switch, first unplug the power cord.

Next, use

a standard

screwdriver

and carefully

pry the left Disc

Cover (55) off

the left Disc

(71).

Next, turn the left Crank Arm (20) until one of the

Magnets (43) on the Pulley (19) is aligned with the

Reed Switch (38). Then, loosen, but do not remove,

the two M4 x 16mm Screws (104), slide the Reed

Switch slightly closer to or away from the Magnet, and

retighten the Screws.

Then, plug in the power cord and turn the left crank

arm for a moment. Repeat the procedure above, if

necessary, until the console displays correct feedback.

Then, reattach the left disc.

HOW TO ADJUST THE DRIVE BELT

If the pedals slip while you are pedaling, even while

the resistance is adjusted to the highest level, the drive

belt may need to be adjusted. To adjust the drive belt,

first unplug the power cord.

Next, using a standard screwdriver, pry off the Shield

Cover (56) and slide it upward.

Then, remove the four M4 x 16mm Screws (not shown)

from the upper and lower ends of the Rear Shield (75),

and remove the Rear Shield.

Then, look between the Shields (73, 74) and locate the

M8 Locknut (102). Tighten the Locknut until the Drive

Belt (113) is tight.

When you have properly adjusted the drive belt, reat-

tach the rear shield and press the shield cover onto the

rear shield.

104

113

102