User`s manual

4. With the help of a second person, carefully lower the Left

and Right Uprights (1,44) untilthe handrails are resting

on the floor.

Attach six Base Pads (57) to the bottom of the Base (59)

in the indicated locations. Note: One extra Base Pad

may be included.

See drawing 4 above. With the help of a second person,

raise the Left and Right Updghts (1,44) until the Base

(59) is restingfiat on the floor.

Before moving the treadmill, see HOW TO MOVE THE

TREADMILL on page 11.

6. Insed two Resistance Bracket Bolts (107) with Bracket

WasherS (70) into the Left Updght (.1). Slide two Star

Washers.(.€03), a_,p_.r..(106), ,andtwo more Star

•Washers (103) onto the Bolts. Make sure that the

Spacer is turned so the widest slde is facing the Left

UpdghL Tighten the Boltsinto the Resistance Bracket

(104) at the lower end ofthe left Upper Body Arm (96).

(Note: It may be necessary to loosen the Resistance

Knob [97] and pivotthe Resistance BmckeL)

Attach the right Upper Body Arm (96) as desqdbed

above. Make sure that both Upper Body Arms are on the

correct side ofthe Console Base (9) as shown.

See drawing 2 on page 5. Feed the slack Wire Hameas

(25) intothe Base (59).

7. Remove the backing from the Adhesive Clip (7"/). Press

the Adhesive Clip onto the Rear Roller Endcap (78) in the "

indicated location. Press the Allen Wrench (76) into the

Adhesive Clip.

Make sure that all parts are tightened before you use the

treadmill. Note: To protect the floor or carpet, place a

mat under the treadmill. For Information On ordering a

mat, see REPLACEMENT PARTS on the back cover.