User`s manual

TROUBLE-SHOOTING
Most treadmill problems can be solved by following the simple steps below. Rnd the symptom that ap-
plies, and follow the steps listed. If further assistance Is needed, call our toil-fros HELPUNE at 1-800-736.
6879, Monday through Saturday, 7 am. until 7 p.m. Central Time (excluding holidays).
...
1. sYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure that the power cord Is pl[Jgged into a surge protector, and that the surge protector is plugged into
a properly grounded outlet. (See HOW TO PLUG IN THE POWER CORD on page 7.) Use only a UL.-listed
surge protector, ra|ed at 15 stops, with a 14-gange cord offive feet or less in length.
b. After the power cord has been plugged in, make sure that the keyis fully Inserted into the console. (See step
1 on page 8.)
c. Check the cimuit breaker located on the treadmill near the
power cord. Ifthe switch protrudes as shown, the circuit
breaker has tripped. To reset the circuit breaker, walt for five
minutes and then press the switch back in.
d. Check the on/off switch located at the front ofthe treadmill
near the power cord. The switch must be In the =on"position.
2. SYMPTOM: THE POWER TURNS OFF DURING USE
Tripped
"On"
Position
a. Check the circ=jitbreaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit
bre;ake_has tripp_l,_Nait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key fully into the console. (See step I on page 8.)
d. Check tomake sure that the on/off switch is in the "on" position. (See 1. d. above.)
e. If the treadmill still will not ran, please call our toll-free HELPLINE.
3. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a. Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord'of five feet or less in length.
b. !f the walking belt is overtightened, treadmill performance may
decrease and the walking belt may be permanently damaged.
Remove the key and UNPLUG THE POWER CORD. Using the
allen wrench, tum both rear miler adjustment belts counterclock-
wise, 114of a tum. When the walking belt is properly tightened,
you shouldbe able to lifteach side of the walking belt 2-3
inches off the walking platform. Be careful to keep the walking
belt centered. Plug in the power cord, insert the key and run the .
treadmill for a few minutes. Repeat until the walking belt is prop-
edy tightened.
Rear Roller Adjustment Bolts
c. If the walking belt still slows when walked on, please call our toll-free HELPLINE.
12