Manual

ASSEMBLY

CAUTION: Read and follow step I below before removing the restraining tie (see drawing 1). If the restrain-

ing tie is removed prematurely, serious bodily injury may result. Assembly requires two people. Set the tread-

mill in a cleared area and remove the packing materials except for the restraining tie. Do not dispose of the

packing materials until assembly is completed. Use the HARDWARE IDENTIFICA'I_ON CHART in the center of

this manual to identify the parts used in assembly. Assembly requires the included allen wrench L==--, a

phillips screwdriver .-=======C_, a 318" wrench '_======O, and two adjustable wrenches C_:=_.

1. Slide the Left Upright (1) onto the left side of the Base

(59): It may be necessary to firmly push down on the

Left Upright until it is fully seated on the Base.

Remove the restraining tie from the Base.

Attach the left handrail to the Base (59) with a Handrail

Bolt (93), 3/8" Washer (67), and Handrail Nut (4). Do not

tighten the Handrail Bolt yet. Using a 3/8" wrench,

tighten two Upright Screws (63) into the Left Upright (1)

and the Base. Be sure to push on the heeds ofthe Upright

Screws while tightening them.

2. Slide the Right Upright (44) onto the right side of the

Base (59). It may be necessary to firmly push down

on the Right Upright until it is fully seated on the

Base. Be careful not to pinch the Wire Harness (25)

between the Right Upright and the Base.

Attach the right handrail to the Base (59) with a Handrail

Bolt (93), 3/8" Washer (67), and Handrail Nut (4). Do not

tighten the Handrail Bolt yet. Using a 3/8" wrench,

tighten two Upright Screws (63) into the Right Upright

(44) and the Base. Be sure to push on the heads of the

Upright Screws while tightening them.

Hand tighten the Handrail Nuts (4) used in steps 1 and 2.

Using a wrench, tighten the Handrail Bolts (93) used in

st-_s +,and 2. F_e_c_ _ the wir_ _ies (not shown) attach-

ing the Console Base (9) to the Right Upright (44).

3. Set the Console Base (9) on the Left and Right Uprights

(1,44). Attach the Console Base with four Screws (75).

While one person carefully feeds any slack Wire Harness

(25) down into the Right Upright (44), a second pe_on

should carefully pull the slack Wire Harness from the

lower end of the Right Upright.

Align the holes in the Book Rack (62) with those in the

Console Base (9). Attach the Book Rack to the Console

Base with four Screws (75) as shown.