User`s manual

10
9. Set the console assembly face down on a soft
surface to avoid scratching the console.
C
arefully pivot the Console Frame (111) to the
position shown. Identify the Left and Right
A
ccessory Trays (104, 106). Attach the
Accessory Trays to the console assembly with
eight M4 x 16mm Screws (37).
Carefully pivot the Console Frame (111) back
down to the console assembly.
9
104
111
Console Assembly
37
3
7
106
10. Identify the Right Handrail (101). Remove the tie
from the Right Handrail. If necessary, press the
M8 Cage Nut (34) back into place.
Hold the Right Handrail (101) near the console
assembly. Route the console wire around the
side of the Right Handrail as shown, and
through the slot in the Right Handrail.
Attach the Right Handrail (101) to the Console
Frame (111) and the console assembly with two
M8 x 25mm Patch Bolts (5), two M8 Star
Washers (10), and an M5 x 16mm Bolt (108)
with a 1/4" Star Washer (73). Make sure the
console wire is not pinched. Start all three
Bolts before tightening any of them.
Attach the Left Handrail (not shown) as de-
scribed above. Note: There is not a wire on
the left side.
101
108
5
111
Slot
Tie
10
10
73
Console
Wire
Console
Assembly
34