User`s manual

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL FOR STORAGE

Before folding the treadmin, adjust the incline to the ]owest

position. If the incline Is not at the lowest position, the

treadmill will be damaged. Next, unplug the power cord.

Caution: "Youmust be able to safely lift 45 pounds (20

kg) In order to raise, lower, or move the treadmlll.

1. Hold the treadmill as shown at the right. Caution: To

avoid pinching your hands, do not hold the treadmill

In the locations indicated by the arrows. To decrease

the possibility of injury, bend your legs and keep your

back straight. As you raise the treadmill, make sure to

lift wlth your legs rather than your back. Raise the

treadmill about halfway to the ve_cal position.

2. Move your right hand to the position shown and hold the

treadmill firmly. Raise the treadmill untilthe storage latch

closes over the frame guide. Make sure that the storage

latch closes fully over the frame guide.

To protect the floor or carpet from damage, place a

mat under the treadmill. Keep the treadmill out of di-

rect sunlight. Do not leave the treadmill in the storage

position in temperatures above 85= FahrenhelL

_, DO not hold here _ _i-_

THE WOODGRAIN-FINISH COVER PANEL

When the treadmill is in the storage position, the woodgrain-

finished cover panel will accent y_tJr'room: If desired, the

cover panel can be removed to display the black-finished

frame cover instead. To remove the cover panel, simplyin-

sert your fingers between the lower end of the cover panel

and the frame cover (see the arrow at the right). Pullthe

cover panel off the panel fasteners, working your way up

until the cover panel Is removed.

After the cover panel is removed, the panel fasteners can be

removed for a cleaner appearance. Using a phillipshead

screwdriver, remove one of the panel screws and panel

fasteners from the frame cover. Tighten the panel screw

back intothe frame cover. Repeat this process, removing

one panel fastener at a time, until all six panel fasteners

are removed. Press the removed panel fasteners onto the

fasteners on the back ofthe cover panel. Store the cover

panel away from moisture and dust.

Cover Panel

Panel

Fastener

--astener