Specifications

ManualsBrandsProForm ManualsOther7.2c

JiaXing Jarol Scientific Instrument Co.,Ltd － JR 6 000 series product s

compensation

rate of VC

【 100 ％】

The parameter is used to adjust the slip frequency

of vector control and improve the precision of

speed control. Properly adjust this parameter can

effectively restrain the static speed bias.

Function

code

Name

Name Setting

Setting

Setting range

range

F3.07

Torque upper

limit

0.0~200.0 ％

【 Depend on

model 】

Note:

�

� 100%

100%

100% setting

setting

setting corresponding

corresponding

corresponding to

rated

rated current.

current.

current. G

G model

model

model :

: 150.0%

150.0%

150.0% ； P

model

model ： 120.0%.

120.0%.

�

� Under

Under

Under torque

torque

torque control,

control,

control, F3.07

F3.07

F3.07 and

and

F3.09

F3.09 are

are

are all

all

all related

related with

with

with torque

torque

torque setting.

setting.

Function

code

Name

Name Setting

Setting

Setting range

range

F3.08

Torque setting

source

0~5

【 0 】

0: Keypad （ F3.09 ）

1:AI1

2:AI2

3: HDI

4:Multi-step speed

5:Communication

1~5: Torque control is valid, which defines the

torque setting source. When the torque setting is

minus, the motor will reverse.

Under speed control mode, output torque matches

load torque automatically, but limited byF3.07. If

the load is above the set upper limit of the torque,

the output torque of the inverter will be limited, and

the rotation speed of the motor will change

automatically.

Under the torque control mode, the inverter will

output torque at the set command, but the output

frequency is limited by the upper or lower limit.

When the set torque is above the load torque, the

output frequency of the inverter will raise to the

upper limit frequency; if the set torque is below the

load torque, the output frequency of the inverter

will decrease to the lower limit frequency. If the