Specifications

ManualsBrandsProForm ManualsOther7.2c

JiaXing Jarol Scientific Instrument Co.,Ltd － JR 6 000 series product s

before performing autotuning. Otherwise it may

cause over-current and over-voltage fault during

autotuning.

Set F0.16 to be 1 then press the DATA/ENT ,

LED will display “ -TUN- ” and flickers. During

“ -TUN- ” is flickering, press the PRG/ESC to exit

autotuning. Press RUN to start the autotung, and

the LED will display “ TUN-0 ” and “ TUN-1 ”

“ RUN/TUNE ” light will flicker. After a few minutes,

LED will display “ -END- ” . That means the

autotuning is finished and return to the stop status.

When “ -TUN- ” flickers, pressing PRG/ESC can

escape from the parameter autotune. During the

autotuning, press the STOP/RST will stop the

autotune.

Note:

Note: Only

Only

Only keypad

keypad

keypad can

can

can control

control

control the

the

the autotuning.

autotuning.

F 0.12

0.12

0.12 will

will

will restore

restore

restore to

to 0

0 automatically

automatically

automatically when

when

when the

the

autotuning

autotuning is

is finished.

finished.

2: Static autotuning:

 If it is difficult to disconnect the load, static

autotuning is recommended.



The operation process is the same as

rotation autotuning except step c.

Function

code

Name

Name Setting

Setting

Setting range

range

F0.1 7

Restore

parameters

0~2 【 0 】

0: No action

1: Inverter restores all parameters to factory

setting.

2: Inverter clear all fault records.

This function code will restore to 0 automatically

when complete the function operation.

F1 Group

Group

Group Start

Start

Start and

and

and Stop

Stop

Control

Function

code

Name

Name Setting

Setting

Setting range

range

F1.00 Start Mode

0~2 【 0 】

0: Start directly: Start the motor at the starting

frequency directly.

1: DC braking and start: Inverter will output DC

current firstly and then start the motor at the

starting frequency. Please refer to description of