Specifications

JAROL Assumes the promotion of energy-saving technology as its own task!
49
The control commands of inverter include: start,
stop, forward run, reverse run, jog, and fault reset
and so on.
0: Keypad (LED extinguishe d );
Both RUN and STOP/RST key are used for
running command control. If Multifunction key
QUICK/JOG is set as FWD/REV switching
function ( F 7.03 is set to 2 ), it will be used to
change the rotating orientation. In
In
In
In running
running
running
running status,
status,
status,
status,
pressing
pressing
pressing
pressing RUN
RUN
RUN
RUN and
and
and
and STOP/RST
STOP/RST
STOP/RST
STOP/RST in
in
in
in the
the
the
the same
same
same
same time
time
time
time
will
will
will
will cause
cause
cause
cause the
the
the
the inverter
inverter
inverter
inverter coast
coast
coast
coast to
to
to
to stop.
stop.
stop.
stop.
1: T erminal (LED flicker ing )
The operation, including forward run, reverse run,
forward jog, reverse jog etc. can be controlled by
multifunctional input terminals.
2: Communication (LED lights on )
The operation of inverter can be controlled by host
through communication.
Function
Function
Function
Function
code
code
code
code
Name
Name
Name
Name Setting
Setting
Setting
Setting range
range
range
range
F0.02
K eypad and
terminal
0~3 【 0 】
UP/DOWN
setting
The frequency can be set by “ ∧ ” , “ ∨ ” and
terminal UP/DOWN. This setting method have
the highest and it cab be combined with setting
channel. It is used to adjust the output frequency
during the comissioning of controlling system.
0 : valid, and the value can be saved when the
inverter is powered off. T he frequency command
can be set and the value can be saved after the
inverter is powered off and it will combinate with
the current frequency when it is repowered on.
1 : valid, and the value can not be saved when
the inverter is powered off. T he frequency
command can be set but the value can not be
saved after the inverter is powered off
2 : invalid, the function of “ ∧ ” , “ ∨ ” and
terminal UP/DOWN is invalid, and the setting will
be cleared automatically.
3 : valid during running. The function of “ ∧ ” ,
“ ∨ ” and terminal UP/DOWN is valid during
running and the setting will be cleared
automatically when the inverter stops.