Specifications

JAROL Assumes the promotion of energy-saving technology as its own task!
45
And then input following parameters according to
the actual motor parameters:
F 2.0 1 : motor rated power.
F 2.0 2 : motor rated frequency;
F 2.0 3 : motor rated speed;
F 2.0 4 : motor rated voltage;
F 2.0 5 : motor rated current;
Set F 0.1 6 to be 1, and for the detail process of
motor parameter autotuning, please refer to the
description of Function Code F 0.1 6 . And then
press RUN on the keypad panel, the inverter will
automatically calculate following parameter of the
motor . See the instruction of F 0.1 6 for the detailed
information.
F 2.0 6 : motor stator resistance;
F 2.0 7 : motor rotor resistance;
F 2.0 8 : motor stator and rotor inductance;
F 2.0 9 :motor stator and rotor mutual
inductance;
F 2. 10 : motor current without load;
Then motor autotuning is finished.
T he keypad will display TUN-1 and TUN-2 during
autotune. W hen the keypad display s -END- , the
parameter autotune has been finished.
Note:
Note:
Note:
Note: The
The
The
The motor
motor
motor
motor should
should
should
should be
be
be
be de-
de-
de-
de- coupled
coupled
coupled
coupled from
from
from
from
the
the
the
the load;
load;
load;
load; otherwise,
otherwise,
otherwise,
otherwise, the
the
the
the motor
motor
motor
motor parameters
parameters
parameters
parameters
obtained
obtained
obtained
obtained by
by
by
by autotuning
autotuning
autotuning
autotuning may
may
may
may be
be
be
be incorrect.
incorrect.
incorrect.
incorrect.
5.2.4
5.2.4
5.2.4
5.2.4 Password
Password
Password
Password setting
setting
setting
setting
JR6000 series inverter provides password
protection function to user s . S et F 7.00 to gain the
password and the password protection becomes
effective instantly after quitting form the function
code editing state. P ress PRG/ESC again to the
function code editing state, "-----" will be displayed .
U nless using the correct password, the operators
cannot enter it. S et F 7.00 to 0 to cancel password
protection function and the password cannot
protect the parameters in the quick menu.
5.2.5
5.2.5
5.2.5
5.2.5 Shortcut
Shortcut
Shortcut
Shortcut menu
menu
menu
menu setting
setting
setting
setting
Shortcut menu, in which parameters in common
use can be programmed, provides a quick way to
view and modify function parameters. In the
shortcut menu, a parameter being displayed as
“ h F 0.11 ” means the function parameter F 0.11.
Modifying parameters in the shortcut menu has
the same effect as doing at normal programming