Specifications

JAROL Assumes the promotion of energy-saving technology as its own task!
21
● Only qualified electricians are allowed to operate on the safe running of the iverter.
● Never carry out any insulation or voltage withstand tests on the cables connecting with the inverter.
● Even if the inverter is stopped , dangerous voltage is present at the input power lines, DC circuit
terminals and motor terminals . W ait for 1 0 minutes even when the inverter is switched off until is
discharge the CHARGE light is off before operation.
● Ground the grounding terminals of the inverter with proper techniques. A nd the resistor should be less
than 10 Ω . Otherwise there is danger of electrical shock and fire.
● Do not connect 3-phase power supply to the output terminals (U, V, W)of the inverter, otherwise damage
to the inverter may occur.
● Please ensure the right connection between the power supply wires and motor wires. C onnect the
power supply to the R , S and T terminalds and connect motor wires to U , V and W terminals.
● Never do wiring or other operations on the servo drive with wet hands. Otherwise there is danger of
electric shock.
Caution
● Verify that the rated voltage of the inverter equals to the voltage of the AC power supply.
● The power wires and motor wires must be permanently fastened and connected.
4.1
4.1
4.1
4.1 Connection of Peripheral Devices