Specifications

JAROL Assumes the promotion of energy-saving technology as its own task!
135
and the modifying conditions) ， below is the instruction ：
“○” : means the set value of the parameter can be modified on stop and running state ；
“ ◎ ” : means the set value of the parameter can not be modified on the running state ；
“●” : means the value of the parameter is the real detection value which can not be modified.
(The inverter has limited the automatic inspection of the modifying character of the parameters to
help users avoid mismodifying)
The
The
The
The seventh
seventh
seventh
seventh line
line
line
line “ No. ” ： The serial number of function code, at the same time, it also means the register
address during communication.
2.
2.
2.
2. “ Parameter radix ” is decimal (DEC), if the parameter is expressed by hex, then the parameter is
separated form each other when editing. The setting range of certain bits are 0~F (hex).
3.
3.
3.
3. ” The default value ” means the function parameter will restore to the default value during default
parameters restoring. But the detected parameter or recorded value won ’ t be restored.
4 、 For a better parameter protection, the inverter provides password protection to the parameters. After
setting the password (set F 07.00 to any non-zero number), the system will come into the state of
password verification firstly after the user press PRG/ESC to come into the function code editing state.
And then “ 0.0.0.0.0. ” will be displayed. Unless the user input right password, they cannot enter into the
system. For the factory setting parameter zone, it needs correct factory password (remind that the users
can not modify the factory parameters by themselves, otherwise, if the parameter setting is incorrect,
damage to the inverter may occur). If the password protection is unlocked, the user can modify the
password freely and the inverter will work as the last setting one. When F 7.00 is set to 0, the password
can be canceled. If F 7.00 is not 0 during powering on, th en the parameter is protected by the password.
When modify the parameters by serial communication, the function of the password follows the above
rules, too.