Specifications

JiaXing Jarol Scientific Instrument Co.,Ltd － JR 6 000 series product s
104
Fb.13
Detection time
cof overtorque
0.1~60.0s
【 0.1s 】
Figure 6 .30 Overtorque control function.
If Fb.11 is set to be 1or 3, and if the output torque
of inverter reaches to Fb.12, and with delay of
Fb.13, this will output the overtorque. A nd the
TRIP light will reflash. If F6.01 ~F6.03 are set to
be10, the output will be valid.
If F b.11 is set to be 2 or 4, when overtorque signal
meets the output conditions,inverter proforms
warming signal OL3,and meanwhile stops the
output.
FC
FC
FC
FC GroupSerialCommunicati
GroupSerialCommunicati
GroupSerialCommunicati
GroupSerialCommunicati
on
on
on
on
Function
Function
Function
Function
code
code
code
code
Name
Name
Name
Name Setting
Setting
Setting
Setting range
range
range
range
FC.00 Local address
0~247 【 1 】
When the master is writing the frame, the
communication address of the slave is set to 0,
the address is the communication address. All
slaves on the MODBUS fieldbus can receive the
frame, but the salve doesn ’ t answer.
The communication of the drive is unique in the
communication net. This is the fundamental for
the point to point communication between the
upper monitor and the drive.
Note
Note
Note
Note ： The
The
The
The address
address
address
address of
of
of
of the
the
the
the slave
slave
slave
slave cannot
cannot
cannot
cannot set
set
set
set to
to
to
to 0.
0.
0.
0.
This parameter determines the slave address
used for communication with master. The value
“ 0 ” is the broadcast address.
Function
Function
Function
Function
code
code
code
code
Name
Name
Name
Name Setting
Setting
Setting
Setting range
range
range
range
FC.01
Baud rate
selection
0~5 【 3 】
0 ： 1200bps
1 ： 2400bps
2 ： 4800bps
3 ： 9600bps
4 ： 19200bps