Installation manual

25
EN
General Information
2.4 Product Description
The SOLIVIA 10 TL / 15 TL / 20 TL / 30 TL are 3 phase grid-tied solar inverters with reactive power
control. These devices convert direct current (DC) electricity from photovoltaic power collected
from PV arrays into 3 phase alternating current (AC) to feed the excess capacity back to the local
mains electrical grid. Using cutting-edge technology allows a wide voltage input range (250~1000
V) and high performance efciency based on a user-friendly operation design. In addition, special
DSP (Digital Signal Processor) design decreases the circuit complication and electronic compo-
nents. Please note that this device does not support off-grid function. The following are the key
features of SOLIVIA 10 / 15 / 20 / 30 TL 3 phase grid-tied solar inverters.
Key Features
● Power Rating: 10 / 15 / 20 / 30 kVA
● Power Balancing (33/67) in asymmetrical dc loading situations
● 3-Phase (3-Phase + N + PE), Grid-tie, Transformerless solar inverter
● Maximum efciency: > 98.0 %
● Europe efciency: > 97.8 %
● Reactive power capability (Cap 0.80 - Ind 0.80)
● Low input current harmonic distortion (THD < 3%) @ full load
● 2 MPP Trackers
● Record up to 30 event logs.
● 5” LCD display
● EPO
The 10 TL / 15TL / 20 TL / 30 TL inverters comply with the latest country regulations and stan-
dards. Please see chapter 7 - Operating the PV Inverter for the complete list of compliance
standards.
2.5 Application & Intended Use
The operation of the solar inverter is as shown as in the gure 2.1. In order to save energy and
electricity, solar inverters convert the DC input power supplied from the PV array into three-phase
AC output power to the grid.
The solar inverter may be used in the following countries as shown: