User`s manual

7
3. Attach the Rear Stabilizer (7) to the Frame
(2) with two M10 x 127mm Patch Screws
(83).
Next, hold the handle on the Frame (2),
p
ress the Latch Button (68), and lower the
Frame until the Rear Stabilizer (7) rests on
the floor.
3
83
7
H
andle
2
68
4. Hold a Hub Cover (75) and a Crank Arm
(36) against the Crank (45).
Align the holes in the Hub Cover (75) and
the Crank Arm (36) with the unused holes in
the left side of the Crank (45).
Insert four Hub Patch Screws (87) into the
Hub Cover (75) and the Crank Arm (36),
and finger tighten the Hub Patch Screws
into the Crank (45). Tighten one Hub
Patch Screw, and then tighten the Hub
Patch Screw across from the first Hub
Patch Screw. Then, tighten the remaining
two Hub Patch Screws.
Repeat this step on the right side of the
elliptical.
Make sure that the Crank Arms (36) are
oriented with the Crank Bushing Sleeves
(43) in the positions shown. Note: There
are no Pulley Screws (98) on the right side.
4
36
45
98
75
87
87
36
43
43