User`s manual

11
12
13
12. Using a small plastic bag to keep your fin-
gers clean, apply a generous amount of the
included grease to the Pivot Axle (74).
I
nsert the Pivot Axle into the Upright (3) and
center it.
Orient the Left Upper Body Leg (11) as
shown, and slide it onto the left end of the
Pivot Axle (74). Slide the Right Upper Body
Leg (12) onto the right end of the Pivot
Axle.
Tighten an M8 x 23mm Patch Screw (84)
with an M8 Washer (88) and a Wave
Washer (111) into each end of the Pivot
Axle (74) at the same time. Make sure that
the Wave Washers are on the ends of the
Pivot Axle.
88
84
111
88
74
3
84
111
12
11
Grease
13. Hold the Left Front Arm Cover (18) and the
Left Rear Arm Cover (19) around the Left
Upper Body Leg (11).
Attach the Arm Covers (18, 19) with three
M4 x 32mm Round Head Screws (105).
Attach the Right Front Arm Cover (20)
and the Right Rear Arm Cover (21) in the
same way.
20
21
105
12
19
18
11