System information

When using the pin field based authentication, make sure that user has valid pin codes set in this field (when the users are automatically generated, the pin
is set to be username+password).
User rights
User rights can be further restricted by several configuration option.
The most useful tool for this is the routing table. You can define were a certain user or a user group can initiate calls.
The following restrictions can be applied per user:
Allowedusers: list of the users or groups (prefixed with 'g') that is allowed to call the user. This can be used to restrict the access to an access number for
example.
AllowedPartners: comma separated list of allowed partners and traffic senders. ‘*’ will allow all. You may restrict the access on gateway or simpacket
level instead of setting it for all simcards separately. Try to use the packet “allowedpartners” setting and leave it as ‘*’ for the simcards!
Enabledprefixes: can be one prefix (with any length) or a list of prefixes with 3,4 or 5 digit separated by comma.
Can be used for traffic senders and gateways too. No need to setup a separate routing pattern if you use this restriction.
EnabledTechPrefixes: enabled techprefixes for the specified gateway (3 digit length numbers separated by comma)
BlockPrefixes: list of called prefixes that will be blocked for the user (techprefix will not be considered here). Numbers listed here must have 7 digit length
and separated with comma.
MaxLines: max concurrent calls allowed (separate value for peak or offpeak)
Maxmonthlycredit: max allowed credit/month even if the user is postpaid
Maxmonthlycreditend: max Maxmonthlycredit (because we increase Maxmonthlycredit by maxmonthlycreditinc every month if the user was active)
Onlylocalaccess: traffic sender traffic will not be forwarded (can call only local users from tb_users and tb_numbers)
Maxmonthlycreditinc: determines how much money we add to Maxmonthlycredit every month
Access Rights: specify wich fields are allowed for the user in the VPC application
0: simcard and traffic sender fields are not shown
1: simcard related fields are not shown (simid, packetname)
2: traffic sender related fields are not shown (name, username)
3: all fields are shown
Global configuration options:
MAXSPEACHLEN: max allowed call duration in sec
allowedusers: max ring time in sec