System information

Postpaid: if the user will prepaid or postpaid
PaymentMode: Check (0), Bank Tranfer (1), Cash (2), Else (3)
ContractNumber: contract for end-users
Allowedpartners:
Allowed traffic senders for the gateway, or allowed gateways for traffic senders.
A list of user id separated by comma or ‘*’
Note that parent users will be checked too
Enabledprefixes: can be one prefix (with any length) or a list of prefixes with 3,4 or 5 digit separated by comma.
Can be used for trafic senders and gateways too. No need to setup a separate routing pattern if you use this restriction.
EnabledTechPrefixes: enabled techprefixes for the specified gateway (3 digit length numbers separated by comma)
BlockPrefixes: list of called prefixes that will be blocked for the user (techprefix will not be considered here). Numbers listed here must have 7 digit
length and separated with comma.
ContractState: the status of the contract
0-
Unknown
1-
Not applicable
2 -In Progress
3 -Active
4 -Terminated
ContractComment: additional comment for sales
Credit: when postpaid, then we also can set a max amount (which will reset in every month)
Enabled: if disabled, it behaves as if it were deleted
DomainName: sipproxy domain name
Port: signaling port
TransIp: secondary signaling ip
TransPort: secondary signaling port
RouteRtpCaller: routing mode if this endpoint is the caller
0=check called settings –this is the preferred settings
1=don't touch the sdp and the rtp
2=sdp correction if necessary
3=route rtp if both behind nat
4= route rtp if caller is behind nat
5= route rtp if called is behind nat
6= route rtp if any endpoint is behind nat
7=always route rtp
RouteRtpCalled: routing mode if this endpoint is the called
0=check caller settings
1=don't touch the sdp and the rtp
2=sdp correction if necessary –this is the preferred settings