System information

The defined commission percent will be calculated for the profit or for the enduserprice. This behavior can be set by the “salescomissionfromprofit” global
config.
Sales can give up for the users some reduction wich will be substracted from their cost. This can be configured with the “reduction” value for the individual
endusers.
5.74. Multihomed setup
UDP ports must be binded to different ip interface (at least the default sip port 5060), or set to different values.
TCP ports must be setup differently
On the gsm gateway set the serverip to the binded ip and the cmdport to the gsmclientport
Change the pipename setting in the gatekeeper.ini
5.75. How to scan your SP for live numbers
The scanner thread can be used to initiate phone calls to a range of phone numbers and will store the validity status of these number in CDR
records.
Phone numbers can be specified by a range (scan_from, scan_untill) or loaded from a text file (scan_filepath).
The speed of the thread can be controlled by the following options: scan_callival, scan_callsperminute, scan_maxcalls (you might specify all these 3
constrains for a better control).
If there is no error in the configuration, the scanner thread will start immediately withing 2 minutes after service startup.
Otherwise the scanner can be started/stopped with the “checkscanner” console command (will start if the parameters are ok and scan_enable
The following global config values must be set accordingly:
scan_enable –set to 0 to disable scanning or 1 to enable (The scanner thread will start automatically if this is set to 1 and will stop automatically on 0 value)
scan_from –range start
scan_untill –range end
scan_filepath-to load the numbers from file
scan_callernum –a valid username (phone number) from “users and devices”. Proper routing must be set for this caller. (A number)
scan_callival –new call attempt interval in msec. (delay between 2 calls)
scan_callsperminute –max calls/minute to initiate
scan_maxcalls –max simoultan calls
scan_stop_at –at what stage the call setup progress will stop.
0=trying,1=progress (default),2=ringing,3=connect
*all global config can be listed if you filter for the “scan” word”
The results can be seen in the marker field of the cdr records: