User`s manual

13. Identify the Right Pedal (14) and the Right Pedal

Arm (12), which are marked with “Right” stickers,

and orient them as shown.

Attach the Right Pedal (14) to the Right Pedal

Arm (12) with three M8 x 10mm Screws (27).

Assemble the Left Pedal (not shown) and the

Left Pedal Arm (not shown) in the same way.

Grease

Arrow

12. Insert the Pivot Axle (26) into the Upright (2), and

center the Pivot Axle.

Using a small plastic bag to keep your fingers

clean, apply a generous amount of the included

grease to both ends of the Pivot Axle (26).

Orient an Upper Body Arm Spacer (47) so that

the arrow points toward the floor. Slide the Upper

Body Arm Spacer onto the right side of the Pivot

Axle (26). Repeat this action on the other side

of the elliptical.

Slide a Small Wave Washer (69) onto the right

side of the Pivot Axle (26). Then, slide the Right

Upper Body Arm (8) onto the Pivot Axle. Repeat

this action on the other side of the elliptical.

Tighten an M8 x 25mm Screw (56) and an M8

Washer (55) into each end of the Pivot Axle (26)

at the same time.

Slide the right Upper Body Arm Cover (28)

upward. Then, press the tabs on an Axle Cap

(46) into the Upper Body Arm Spacer (47).

Repeat this action on the other side of the

elliptical.

Slide the Upper Body Arm Cover (28) downward

to cover the M8 x 41mm Bolts (not shown).

Repeat this action on the other side of the

elliptical.