Hydrotherapy Spa Patent Pending Model No. 831.210050 Serial No. USER'S MANUAL Write the serial number in the space above for reference. The serial number decal is on the frame behind the access cover. QUESTIONS? PLEASE CALL DIRECT TO OUR TOLL-FREE CUSTOMER HOT LINE. The trained technicians on our customer hot line will provide immediate assistance, free of charge to you. CUSTOMER HOT LINE: 1-800-999-3756 Mon.ÐFri., 6 a.m.Ð6 p.m.
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 CHOOSING A LOCATION FOR THE HYDROTHERAPY SPA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7 SET-UP AND ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IMPORTANT SAFETY INSTRUCTIONS WARNING: TO REDUCE THE RISK OF DROWNING, ELECTRIC SHOCK, OR SERIOUS INJURY, READ THE FOLLOWING IMPORTANT PRECAUTIONS BEFORE USING THE RESTORATION 5.1. READ AND FOLLOW ALL INSTRUCTIONS 1. It is the responsibility of the owner to ensure that all users of the hydrotherapy spa are adequately informed of all precautions. 9. Do not bring any object into the hydrotherapy spa that could damage the spa shell. 10. Never insert any object into any opening. 2.
20. DANGERÑIf you will be using the hydrotherapy spa outside, do not bury the power cord; you should also keep the power cord away from lawn mowers, hedge trimmers, and other similar equipment. 27. DANGERÑRisk of drowning: Exercise extreme caution to prevent unauthorized and unsupervised use of the hydrotherapy spa by children. Children must always be supervised. 21. WARNINGÑThe hydrotherapy spa must be wired directly into a 240 volt power source equipped with a Ground Fault Circuit Interrupter (GFCI).
34. WARNINGÑTo reduce the risk of injury or drowning: Consult your physician about possible side-effects of any medications you may be taking before using the hydrotherapy spa. Heat from the water, in conjunction with some medications may cause drowsiness and increase the risk of drowning. Others can effect blood pressure, heart rate, and circulation. 36. If you feel pain or dizziness at any time while using the hydrotherapy spa, discontinue use and contact a physician. 37.
BEFORE YOU BEGIN Thank you for selecting the innovative PROFORM¨ RESTORATION 5.1 hydrotherapy spa. The RESTORATION 5.1 hydrotherapy spa offers the features and quality of a traditional hot tub at an affordable price. Best of all, the RESTORATION 5.1 hydrotherapy spa provides the benefits of hydrotherapy in the comfort and privacy of your own home. Hydrotherapy is a proven method for soothing tired muscles after exercise or for relieving the stress of a busy life.
CHOOSING A LOCATION FOR THE HYDROTHERAPY SPA There are many factors to consider when choosing a location to set up the hydrotherapy spa. These factors vary depending on whether you use the hydrotherapy spa inside or outside. We have listed several factors you may wish to consider as you decide where you want to use the hydrotherapy spa. If you set up the hydrotherapy spa inside: If you set up the hydrotherapy spa outside: 1. The hydrotherapy spa will increase the level of humidity in your home.
SET-UP AND ASSEMBLY Before beginning assembly, carefully read the following information and instructions: ¥ Read each assembly step before you begin. ¥ Tighten all parts as you assemble them, unless instructed to do otherwise. ¥ Place all parts in a cleared area and remove the packing materials from the spa shell; do not dispose of the packing materials until assembly is completed and the spa is in operation. ASSEMBLY REQUIRES THE FOLLOWING TOOLS (not included): ¥ Assembly requires two people.
3. Place the Spa Cover (18) over the spa. Be sure that the Spa Cover is properly centered. 3 Strap Latch Snap a Buckle (2) onto each of the four latches on the Spa Cover (18). 2 15 See the inset drawing. Position one of the Buckles (2) on the wood panels on the Spa Unit (15). Hold the Buckle in place so the strap on the Spa Cover (18) is tight. (Note: It may be easier to position the Buckle if a second person holds the strap on the opposite side of the Spa Cover tight.) The Spa Cover must be tight.
WIRING THE RESTORATION 5.1 The RESTORATION 5.1 is designed to operate with a 240 volt AC power source; it must be wired by a qualified electrician directly into a 240 volt AC GFCI in your home. The steps below are intended to be used as a reference for the qualified electrician who wires your spa and installs the 240 volt AC GFCI in your home. WARNING: Only a qualified electrician should perform this procedure. 1.
5. For a 40 amp 240 volt AC power supply, set the jumper J1 to pins 1 and 2 on the power board and leave the other jumpers at the factory settings, as shown at the right. This will allow the heater and the pump to operate at high speed simultaneously. 5 Jumper settings for a 240 volt AC, 40 amp power supply 6. Secure the power cord by tightening the screws in the wire clamp on the Control Unit (14). 6 14 Screws Power Cord Wire Clamp 7.
USING THE HYDROTHERAPY SPA The hydrotherapy spa is designed to seat five adults. The fifteen thera-jets can be regulated to provide a relaxing massage to sooth away stress, and the strength of the water massage can be adjusted by the air control. The hydrotherapy spa holds 200 gallons of water and offers an automatic, programmable heating (41¡F to 104¡F) and filtration system. If the level is too low, add half of one of the ÒQUICK pHix It UPÓ packets to the water.
SPA SHELL DIAGRAM G A C A B E F D B B A D A A SPA OPERATION Refer to the diagram above. The function of each component is explained below: The suction vents (D) located near the floor of the spa brings the water into the pump in order to operate the system. The suction covers should always be in place over the suction vents. Never operate the spa without the suction covers in place. The eight uni-directional thera-jets (A) are located on both sides of the spa.
CONSOLE DIAGRAM USING THE CONSOLE Filter On: This LED indicator is lit when the spa is running the filter cycle. Refer to the console diagram above. The function of each console control is explained below: Note: To keep the heat and filter cycles from running, shut off the circuit breaker or GFCI. Temperature Display: During normal use this display shows the actual water temperature. When the Set Temp indicator is lit, the display shows the set temperature.
ADJUSTING THE FILTER CYCLE Each cycle can run for 60, 120, or 180 minutes. To change the length of the cycle, press the light and up buttons at the same time. The length of the cycle will appear in the temperature display. Use the up and down buttons to select the desired cycle length. The spa filter cycle runs automatically to clean the water in the spa. However, the number of times that the filter cycle needs to run depends on how often the spa is used.
MAINTENANCE The hydrotherapy spa is designed to provide you with years of enjoyment. Please follow the guidelines below to properly maintain your hydrotherapy spa. MAINTAINING THE SPA COVER The spa cover should be cleaned monthly. To clean the spa cover, use water and a non-abrasive cleaner on the entire cover. Rinse the cover with a garden hose to remove any cleaner residue. Dry the cover entirely. You should also use a non-silicone based vinyl conditioner on the cover after you clean it.
SANITIZING THE HYDROTHERAPY SPA level is not properly maintained. Damage caused by improper pH levels is not covered under the warranty. Please refer to your local pool and spa supplier for information concerning which chemicals you should use in your area to sanitize the spa. To maintain the proper pH level, you should test the pH of the water regularly. You will need a pH test kit (not included), which can be obtained at a pool and spa supply store. The pH reading should be between 7.2 and 7.8.
should also be drained if you will not be using it for long periods of time. The spa must always be drained before major repairs are made. To drain the pump, remove the access Pump cover from the spa unit (see ATTACHING AND REMOVING THE ACCESS COVER on page 17). Drain Plug Locate the pump inside the spa unit. Remove the drain plug from the pump. Tip the spa jet unit slightly, until all the water has drained from the pump. Replace the drain plug.
WINTER USE AND CARE The hydrotherapy spa is designed for year-round use. If you decide to store the hydrotherapy spa for the winter, store it in a warm, dry location. Follow the steps below to winterize the hydrotherapy spa. 1. Drain the spa (see DRAINING THE HYDROTHERAPY SPA on pages 17 and 18). 2. Remove all remaining water from the spa shell. Dry the spa shell with towels. 3. Set the air control on the console to the lowest setting. Use a wet/dry vacuum to pull any remaining water from the system.
TROUBLE-SHOOTING Most problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time. 1. SYMPTOM: THE SPA WILL NOT OPERATE and the room temperature is maintained at 70¡F, it will take approximately 5 to 7 hours for the water to reach the set temperature. a.
ment for excess water, and watch the pump unit while it is operating to see if water drips from any of the plumbing. If you can identify the location of the leak inside the spa jet unit, tighten the clamp or replace the damaged seal. 10. SYMPTOM: THE SPA CONTINUES TO RUN AFTER IT HAS BEEN SHUT OFF a. To turn the spa jets on high, press the Pump button once. To turn the spa jets on low, press the control twice. To turn the spa jets off, press the control three times.
PART LISTÑModel No. 831.210050 Key No. Qty. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 8 4 6 4 4 1 1 4 1 1 1 1 1 1 1 1 1 1 4 2 2 2 R0498A Key No. Qty.
EXPLODED DRAWINGÑModel No. 831.
Model No. 831.210050 QUESTIONS? As a manufacturer, we are committed to providing complete customer satisfaction. If you have questions, or find that there are missing or damaged parts, we will guarantee complete satisfaction through direct assistance from our factory. TO AVOID UNNECESSARY DELAYS, PLEASE CALL DIRECT TO OUR TOLL-FREE CUSTOMER HOT LINE. The trained technicians on our customer hot line will provide immediate assistance, free of charge to you.
