User`s manual

11. Attach the Left HandUebar Cover (109) to the ConsoUe
(5) with three M4 x 16mm Screws (66), Attach the
Right HandUebarCover (110) in the same way.
See assemMy step 9. Tighten the eight M6 x 16mm
Tapered Button Screws (107).
12. Hug one end of the Power SuppUy(115) into the jack
at the rear of the eHipticaUcrosstrainer. Hug the other
end of the Power SuppUyinto an appropriate outlet
that is propedy installed in accordance with aH UocaU
codes and ordinances,
Note: The ConsoUe (5) can be operated with batteries
(not incUuded) instead of the Power SuppUy (96) if
desired, To install batteries, follow the instructions
beUow.
See the inset drawing, Press the indicated tab on the
battery drawer and pull the battery drawer down,
Press four "D" batteries into the battery dips; make
sure that the batteries are oriented as shown by
the markings inside of the battery clips. Then,
close the battery drawer, Note: Alkaline batteries are
recommended,
11
109
66
12 :_,
110
66
\
\
\
Power
Jack
/
_ 96
Batteries
Drawer
Tab
13. Make sure that aH parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may
be left over after assembly is completed, To protect the floor or carpet from damage, place a mat under the
elliptical crosstrainer.
9