User`s manual

identify the Left Handiebar (9), which is marked with a

sticker, insert the Left Handiebar into one of the

HandHebar Legs (79); make sure that the HandJebar

Leg is turned so the hexagonaJ hobs are on the

indicated side, Attach the Left Handiebar to the

Handiebar Leg with two M8 x 43mm Button Boits (50)

and two M8 Nyion Locknuts (46), Make sure that the

NyJon Locknuts are seated in the he×agonat holes.

Do not futty tighten the Sutton Bolts yet.

Attach the Right Handbbar (not shown} to the

other Handlebar Leg (not shown} in the same way.

Appiy a generous amount of the inciuded grease to the

Pivot Axie (108) and to the two M8,5 Smali Washers

(53), insert the Pivot Axie into the Upright (2) and center

it, Reappiy grease to both sides of the Pivot Axie,

identify the Left and Right Handiebars (9, 10), which

are marked with stickers, Siide a Handiebar Spacer

(25) onto the short tube on each Handiebar, and siide

the Handiebars onto the Pivot Axie (108), Make sure

that the Handlebars are on the correct sides.

Orient the two Handlebar Caps (23) as shown, and

press the small tabs on the Handlebar Caps into the

two Handlebar Spacers (25), Tighten an M8 x 19mm

Shoulder Screw (22) with an M8.5 Small Washer (53)

into each end of the Pivot Axle (108),

Apply a thin film of grease to the shaft of a Union Bolt

Set (27) and to the two Bushings (28) in the left

Handlebar Leg (79),

Attach the left Handlebar Leg (79) to the left Flex Bar

(14) with the Union Bolt Set (27),

See assembly step 5 above, Tighten the two M8 x

43mm Button Bolts (50) in the left Handlebar Leg (79),

Make sure that the M8 Nyton Locknuts (46} are

seated in the hexagonal hotes.

Repeat this step to attach the right Handlebar Leg

(79) to the right Flex Bar (14),

53 23

9 L \

_ Tube

gonal

Hobs

1 53

27 \,