Owner's Manual

Inspect and tighten all parts of the elliptical regularly.

Replace any worn parts immediately.

To clean the elliptical, use a damp cloth and a small

amount of mild soap. IMPORTANT: To avoid damage

to the console, keep liquids away from the console

and keep the console out of direct sunlight.

CONSOLE TROUBLESHOOTING

If the console does not display your heart rate when

you hold the handgrip heart rate monitor, or if the dis-

played heart rate appears to be too high or too low, see

step 5 on page 19.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted.

To adjust the reed

switch, you must

first remove the Top

Shield (20). Using

a flat screwdriver,

release the tabs on

the front and rear of

the Top Shield and

then remove the Top

Shield.

Next, locate the Reed Switch (69). Loosen, but do not

remove, the M4 x 16mm Screw (93).

Next, rotate the Large Pulley (74) until a Magnet (75)

is aligned with the Reed Switch (69). Slide the Reed

Switch slightly toward or away from the Magnet. Then,

retighten the M4 x 16mm Screw (93).

Rotate the Large Pulley (74) for a moment. Repeat

these actions until the console displays correct

feedback.

When the reed switch is correctly adjusted, reattach

the top shield.

MAINTENANCE AND TROUBLESHOOTING