Specifications

INSTALLATION

Power supply:

The TX-168PHB needs power to operate. Use the included power adaptor or

install 4x 1,5 Volt battery, size AAA.

ower adaptor: One power adaptor is included. Use this one or a version with the

following specifications:

input: 230 Volt, 50, Hz AC

output: 6 - 9 Volt DC, 200mA,

Batter

ies: open the battery compartment (direct below the handset) and install 4

pcs 1.5V AAA batteries. Mind the polarity. Batteries are not included.

Attention:

always disconnect the telephone form the telephone outlet when

batteries are to be installed or replaced. See also page 11.

Telephonecord & handsetcord:

1. connect the supplied handsetcord between the handset and base

2. connect the telephonecord to the backside of the telephone; push the

connectors till you hear a click

3. plug the telephone plug into your telephone outlet

Wall mount:

1. drill two holes in the wall with a distance of 9cm and insert two screws; let

the heads of the screws stick out a few millimeters of the wall

2. remove the handsetholder, rotate it 180° and replace it; this holder will hold

the handset when wall mounted

3. hang the unit on the wall and fixate the telephone wire by means of

cable-clips

Once the power adaptor is plugged into a 230V mains outlet and / or the batte-

ries have been installed, the telephone is ready for use.