Technical data

ELECTRONIC CONTROL PANEL
Page 14
DUPLEX ECO ALTERNATING:
 The 2 Simplex systems, that make up a Duplex system,
must be programmed individually; the program does NOT
necessarily have to be the same on the 2 Simplex systems!
1. Press the scroll

button and hold it for 5 sec until the
display shows:
2. Within 10 sec, press the up

button; the display will
show:
 Press the up

or down

button to set the hardness
unit. Make sure to also adjust/convert the exchange
capacity!
3. Press the scroll

button again; the display will show:
 Press the up

or down

button to set the
exchange capacity per litre of resin.
4. Press the scroll

button again; the display will show:
 Press the up

or down

button to set the volume
of resin.
5. Press the scroll

button again; the display will show:
 Press the up

or down

button to set the length
of the regeneration cycle.
 Press the scroll

button again to advance to the next
regeneration cycle.
Cycle 1
Backwash
Cycle 2
Brine draw/slow
rinse
Cycle 3
Fast rinse/refill
6. Press the scroll

button again; the display will show:
 Press the up

or down

button to set the type of
water meter sensor.
7. Press the scroll

button again; the display will show:
 Press the up

or down

button to save the
program into the NOVRAM® and exit the
programming level.
8. Repeat steps 1-7 for both Simplex systems.
Cycle 1: XX min
System Check
HardUnit:°f
Resin:XXX liters
ExCap:5.5°f M3/L
MTR:SNAP SENSOR
Exit