Technical data

ELECTRONIC CONTROL PANEL
Page 11
MANUAL REGENERATION
It is possible to manually initiate a regeneration.
1. Press the scroll

button repeatedly until the display
shows:
 If the control valve is left in this position, the count-
down timer will count down to 0 sec and start a
regeneration.
 To cancel this mode, press the scroll

button before
the countdown timer has reached 0 sec; the control
valve will return to the service mode.
2. Press the scroll

button again if you want to manually
advance the control valve to the next regeneration cycle.
DRIVE MOTOR SPEED
The drive motor of the control valve, that drives the valve
body to its different regeneration positions, will start-up at
low speed to reduce its noise level. To increase the speed of
the drive motor, simply press the scroll

button as soon as
the drive motor is activated.
PROGRAMMING INSTRUCTIONS –
INSTALLER
 Before entering the programming mode, make sure that
the control valve is in the service mode.
1. Press the scroll

button; the display will show:
 Press the up

or down

button to set the
language.
2. Press the scroll

button again; the display will show
(does not apply to Duplex Eco Alternating!):
 Press the up

button or down

button to set the
time of day.
3. Press the scroll

button again; the display will show:
Simplex Tempo:
 Press the up

or down

button to set the number
of days between regenerations.
Simplex Eco, Duplex/Triplex Eco:
 Press the up

or down

button to set the hardness
of the incoming untreated water.
Language:English
Set time: 20:51
Interval:
XX
Days
Regen in 10 sec
Set Hardn.: XX°f