Service manual

Printed in U.S.A.
Page 5
ProFloSE Downflow
Control Start-Up Procedures (Cont’d.)
Depending on current control programming, option setting displays that are not required to be set will not be viewed.
3.
Set Control Programming
1. The first option setting display that appears in the Program Mode is Treated Water Capacity. Using the Set Up or Dow
n
Buttons, set the amount of treated water that can flow through the unit before a regeneration is required. For Example:
3. Push the Extra Cycle Button. The third option setting display that appears is Regeneration Time. Using the Set Up or
Down Buttons, set the maximum number of days b3efore a regeneration cycle must occur. For Example:
2. Push the Extra Cycle Button. The second option setting display that appears is Regeneration Time. Using the Set Up or
Down Buttons, set the desired time of day when a regeneration can occur, if required. For Example:
4. Control programming is now complete. Push the Extra Cycle Button. This will exit the control from the Programming
Mode, and resume Normal Operation.