Installation Sheet

285mm
210mm
Atemplate has been included tohelp you cut an accurate
openingin the countertop. Cut out the template, positionthe
template asdesired, and trace it onthecountertop.
Drilla clearancehole inside the cutout line. Cut out the countertop opening by carefully following the line
traced fromthe template.Contractyour countertop distributor
for the bestmethod ofcutting your specific type ofcountertop
(granite, laminate, etc).
Drillthe required faucet holes and install the faucet according
tothe manufacturer’sinstructions.
Determine placement ofclip brackets asindicated by template.
Pre-drillholesaccording to method recommended for your counterop material.
Option A under mount installation
INSTALLING YOUR NEW SINK
NOTE:THIS TEMPLATEIS ONLYA GUKDEACTUAL
SINK SHOULD BE PRESENT TO ENSUE PERFECT
CUTOUT. ILLUSTRATION BELOWIS OFA SAMPLE
TEMPLATE EACH SINK MODEL IS SUPPLIED WITH
ACUSTOMIZEDTEMPLATE.
Clean the underside of the countertoop,making sure the
surface is smooth and free of defect .
Apply a bead of silicone sealant along edge on underside of countertop. Position and align sink over opening.Press si nk on to
silicone seal. Re-check alignment and tighten clip brackets. Wipe off any excess sealant immediately with a damp cloth
it will be difficult to remove if allowe d to d ry.
Apply additional sealant if necessary.
Allow the sealan t to cur before proceeding.
Connect the supply lines to the faucet and complete the
faucet Installation , follwing the instructions packed with the faucet.
Connect drain assembly hand tight to check alignmen t
Secure joint for watert ight assembly.
I
nstall the garbage disposal, if applicable.
3
Option B top mount installation
1. If youareinstalling a sinkto a new
a. Place sink upside down in the desired
Position andtrace completely the outside rim
Usinga soft lead pencil.
b.Thenremove sink from countertop and draw
Cutoutline 5/16"inside the original rim with
1- 1/2"radius at comers line. 2. Using a sabre saw, start cuttingfrom the
Drilled hole along the cutout line. Support Cutoutuntil the cut is completed.
3.Apply caulking compound to theperimeter of
The cutout opening.
4.
5. 6.
Attached faucet and sink strainer as
necessary. Follow installation instructions
supplied with your faucet.
Insert clips into
the channel. Locate 3 clips in
front andback, and two clips to each side.Be
sureto arrange the clips evening around the sink. Positionthe clip assemblyparallel to the channel. Place thesink carefully into thecutout
opening and be sure it is properly seated.
make suresink rim is covered with caulking
all around andpress down firmly around the
permitierof the sink rim.
SinkType
Single Bowl Double Bowl Bar Sink
Clip Use
2 each in the front andback:2 on each side
3 each in the front andback:2 on each side
1 each in the front andback:1 on each side
7.Rotate the clamp on the clip 90 degrees to
the channel and
tighten screw clockwise.
from the center clip using a long screwdriver. 8.Tighten all clips evenly and do not over
tighten as damage can result.
9.Install drain and water supply fittings as
necessary. Wipe excess caulkingcompound
and check carefully as some adjustments for
positioning and tightness may be reqiured.
4