Installation Sheet

INSTALLATION INSTRUCTIONS

1. Read all instructions carefully prior to installation.

2. Separate the drain

To install, separate the drain into a top drain body (parts #1-4) and bottom (parts #5-7) drain body.

3. Apply silicone

Apply a bead of silicone to the underside of the top portion, then place it through the drain hole in the shower base.

4. Connect drain parts

From underneath the shower, place the rubber washer, then paper (“friction”) washer, then bottom body portion and

tighten. The friction washer protects the rubber from damage while the bottom portion is threaded on and tightened.

5. Remove excess silicone

From the top side of the shower base, remove excess silicone that has been pressed out when the drain was tightened.

6. Solvent weld drain to pipe

Now solvent weld the drain pipe to the hub of the newly installed drain using the appropriate solvent cement. Allow 24

hours for the silicone to cure and be sure to check installation for leaks.

CAUTION: Do not use oil-based putty with plastic drains.

Before purchase and use of a product, please review the product application and be

certain the product, installation and use will be in compliance with any applicable codes and regulations.

Distributed Exclusively by Ferguson and Wolseley Canada

PFP600, PFA600

Solvent Weld Shower

Drains