Specification

Safety Data Sheet 1 of 2
SECTION 1 - PRODUCT NAME AND COMPANY IDENTIFICATION
Product Name: PROFLEX® Elastomeric Membranes
Recommended Use: Flooring underlayment
Restriction on Use: None
Manufacturer / Supplier: PROFLEX® Products, Inc.
2826 Broadway Center Blvd.
Brandon, FL 33510
Emergency Contact: [phone] CHEMTREC (USA)
SECTION 2 - HAZARDS IDENTIFICATION
Hazard Classification: These products are classified as Articles under the US OSHA Hazard Communication Standard 29CFR
1910.1200, Canada WHMIS and the GHS. A Safety Data Sheet is not required for these products. The following information is provided
to assist in the safe use of our products.
SECTION 3 - COMPOSITION/INFORMATION ON INGREDIENTS
Membranes consist of a top and bottom compound of asphalt and polyethylene, polypropylene or styrene-butadiene- styrene resins, a fiberglass
or polyester mat, and a top and bottom surface of plastic film, sand or granules.
The membranes may be self-adhered, heat applied using a torch or hot air gun or applied with an adhesive.
Under normal conditions of use, these products will not release hazardous chemicals. Any sand or roofing granules that may fall off during
installation are not respirable and will not present a hazard to workers. The installation, use and removal of these products will not create
respirable dust from these surface treatments.
SECTION 4 - FIRST AID MEASURES
In general, no first aid is required after handling these membranes. If burns occur from installation with a hot air gun or torch, quickly immerse
the burned area in cold water and get medical attention for treatment of the burn if needed.
Eyes: If particles from surface coating enter the eye, flush eyes with water while lifting the upper and lower lids. Get medical attention if
irritation persists.
SECTION 5 - FIRE FIGHTING MEASURES
Extinguishing Media: In general water is most effective for ordinary combustibles.
Special Protective Equipment and Precautions for Fire-fighters: Firefighters should wear full emergency equipment and NIOSH
approved positive pressure self-contained breathing apparatus.
Specific Hazards Arising from the Chemical: This product is not easily ignited and burns with difficulty. Combustion products may
include oxides of carbon, nitrogen and sulfur, hydrogen sulfide, formaldehyde, acetaldehyde, and irritating smoke.
SECTION 6 - ACCIDENTAL RELEASE MEASURES
Pick up and use or dispose of properly.
SECTION 7 - HANDLING and STORAGE
No special handling or storage is required.