Installation Guide

HYDRA-SEAL
1 of 4
1. PRODUCT NAME
Hydra-Seal
2. MANUFACTURER
PROFLEX® Products, Inc.
2826 Broadway Center Blvd
Brandon, Florida 33510
Telephone: [phone]
Toll Free: 877-577-6353
Fax: [phone]
Internet: www.proflex.us
3. PRODUCT DESCRIPTION
PROFLEX® Hydra-Seal is a thin, load bearing, crack isolation, waterproof membrane, it provides a monolithic transition for
crack-isolation and waterproofing applications. The material is installed in a semi-fluid state and can be applied to most shapes or
irregular form such as base flashings, walls, etc.
Uses
• Interior and exterior applications
• Swimming pools, fountains and water
features
• Shower pans, stalls and tub surrounds
• Industrial, commercial and residential
bathrooms and laundries
• Spas and hot tubs
• Kitchens and food processing areas
• Terraces and balconies over unoccupied
spaces
• Countertops and facades
• Steam rooms (when used in conjunction
with a vapor barrier)
Advantages
• Single component Cold applied
• Non-flammable
• Moisture vapor resistant up to 7lbs. / 1000 sq.ft. /
24 HR CaCl test
• Bonds directly to metal, PVC and ABS plumbing
fixtures only
• Thin; only 40mil thick when fully cured
• Changes in color
• Anti-fracture protection of up to 1/4" over shrinkage
and other non-structural cracks
• Exceeds ANSI A118.10 and A118.12
• Safe—no solvents and non-flammable
• Install tile, brick and stone directly onto membrane
Suitable Substrates
• Concrete
• Concrete & Brick
Masonry
• Cement Mortar Beds
• Cement Plaster
• Gypsum Wallboard*
• Exterior Glue Plywood*
• Ceramic Tile & Stone**
• Cement Terrazzo**
• Cement Backer Board***
• Poured Gypsum
Underlayment†
* Interior applications only.
** If primed with PROFLEX® Super Prime.
***Consult cement backer board manufacturer for specific installation recommendations and to verify acceptability for exterior use.
† Interior use only. Follow TCNA Guidelines/ Methods: F200, RH111, RH122, F180
Packaging
5 gal pail liquid (36 units/pallet)
4 x 1 gal pails of liquid packed in a carton (45 cartons/pallet)
Approximate Coverage
1 Gallon - 80 sq. ft. at 30-35 mil wet film thickness - single coat crack
isolation application
1 Gallon - 50 sq. ft. at 20-25 mil wet film thickness - two coat
waterproofing application
Shelf Life
Factory sealed containers of product are guaranteed to be of first quality for one (1) year if stored at temperatures >40°F and <90°F
Limitations
● DO NOT bond to OSB, particle board, interior glue plywood, luan, Masonite® or hardwood surfaces.
● Do not use as a primary roofing membrane over occupied space.
● Do not use over dynamic expansion joints, structural cracks or cracks with vertical differential movement
● The installation of Waterproofing Membranes in submerged applications must be installed in a manner that creates a
continuous "waterproof pan effect" without voids or interruptions.
● Do not use over cracks >1/4" in width.
● Do not use as a vapor barrier (especially in steam rooms).
● Do not expose unprotected membrane to sun or weather for more than 30 days.
Data Sheets are subject to change without notice. For latest revision, visit www.proflex.us 060517