Operation Manual

ManualsBrandsProfile ManualsMiscellaneousPLI-134

LAMP WITH ENERGY-SAVING LIGHT

EN - 1

PLI-134

We thank you for the purchase of this Profile

product. Note: It is important that you read this

manual carefully before using the product and

be sure to save this manual for possible use

later.

Note

Check if building regulations apply to your area

whereby you must have the lamp installed by

an accredited electrician. An electrician can

give you information about correct wiring.

Never install the fitting outside in rainy

weather.

SWITCH OFF THE POWER BEFORE YOU

INSTALL THE LAMP.

Correct installation

 With installation outside preferably choose a

place under a roof.

 Connect the lamp to a circuit with wall

switch.

 Unscrew the stainless steel bolts on the side

to take the holder from the fitting.

 Fix the holder to the wall with 2 screws.

 Fix the lamp back on the assembled holder.

 Remove the cover of the cable connection.

 Pull the power supply wires through the

opening with the rubber packing.

 The lamp must be connected to mains

voltage of 230V, max. fusing 16A.

 Connect the wires according to figures 1

and

 Screw the cable connection cover tight

again.

 Always respect the instructions on the

identification label of the connected power

cables.

 Other uses than described above can cause

damage to the product and increase the risk

of short-circuit, fire, electric shocks, etc.

Fig.1

 The product may not be adapted as a whole.

The safety instructions must be strictly

observed.

Safety instructions

 The importer accepts no responsibility for

damage claims with respect to objects or

persons that result from incorrect use or non-

compliance with the safety instructions. Any

damage claims in such cases will be

declared null and void.

 When replacing the R7S 24W energy-saving

light the power supply must be switched off.

Do not exceed the maximum wattage of

24W.

 Always replace cracked or broken glass by

glass with the same properties as the original

glass.

Technical information

 Working voltage: 230V AC (50/60 Hz)

 Maximum lamp power: 24W

 Maximum current strength: 10/16A

 Dustproof and splashproof: IP44.

 Passive infrared sensor (PIR)

 Sensor angle: 120°

 Sensor range: 10 metres at with 25°C.

 Lighting time: +/- 5 sec. – 10 min.

Setting the functions

1) Setting the light intensity (lux)

With the LUX Switch you adjust the working of

the sensor to match the intensity of the

ambient light.

Fig. 2

L = phase

= earthing

* N = neutral wire

Summary of content (2 pages)

PAGE 1
LAMP WITH ENERGY-SAVING LIGHT PLI-134 EN - 1 We thank you for the purchase of this Profile product. Note: It is important that you read this manual carefully before using the product and be sure to save this manual for possible use later. The product may not be adapted as a whole. The safety instructions must be strictly observed.
PAGE 2
LAMP WITH ENERGY-SAVING LIGHT PLI-134 If the arrow is pointing to the sun the sensor responds in both daylight and at night. If the arrow is pointing to the moon the sensor will only respond at night. In between the sensor responds in half-light. 2) Setting the lighting time (TIME) With this adjusting knob you can set the period of the light staying on after switching on. You can set the time from 5 sec. to 10 min.