Operation Manual

Profile Doorbell with video function EN - 1
PAC-350
We thank you for the purchase of this Profile product.
Caution: It is important that you read this manual before
using the product. Then keep this manual in a safe place.
Technical information
A) Internal unit
 Working voltage: DC12V, 350mA
 Mains current: 220mA + 80mA
 Operating temperature: -10°C ~ +50°C
 Maximum humidity: 85%
 Pixels (Hxv): 480(H)*240(V)dot
 Active screen size: 72.0(H)*50.544(V)mm
 Screen size: 2.36 inch (Diagonal)
 Receiving frequency: ISM 2.400MHz ~ 2.483MHz
 Video system: PAL/NTSC
B) External unit with camera
 AA battery 1.5V (excl..)
 Image angle: 50°
 Operating frequency: 2414MHz; 2432MHz; 2450MHz;
2468MHz.
 Operating temperature: -10°C ~ +50°C
 Dimensions: 94 (L) x 58(B) x 21(H) mm
 Range to internal unit: 100M
C) Adapter (included) :
 100 - 240V ~ 50/60Hz 0.5A
 Output: 350mA, 4.2VA**, 12V
Safety measures
 To ensure the safe operation of your Profile doorbell
with video function the appliance must be assembled
and connected in accordance with the instructions in
the manual. If these instruction are disregarded the
responsibility of the supplier/manufacturer no longer
applies.
 The batteries may not be exposed to high
temperatures such as caused by sunlight or fire. Also
never
throw the batteries in the rubbish bin. Take them
to a civic amenity site to protect the environment.
 When installing the batteries always note the polarity.
 Never immerse the appliance in water.
 When the appliance is not to be used for a longer
period always remove the plug from the plug socket
and the batteries.
Operation and use
Always first remove the protective foil from the internal
unit screen. If you leave the protective foil on the screen
this will shorten the working life of your device.
A) Internal unit
1
2
3
4
1. Power ON/Off
2. Channel selection switch
3. LED channel indicator:
CH +/- 1 --- LED light 1 x on
CH +/- 2 --- LED light 2 x on
CH +/- 3 --- LED light 3 x on
CH +/- 4 --- LED light 4 x on
4. Light intensity button
 You can fasten the internal unit to the wall or a flat
surface. Then make the connection with the adapter
and plug this into the plug socket.
B) External unit with camera
Camera
Bell push-button