User manual

59
PC-ES1109_IM 21.04.16
8 Heater indicator lamp (green)
9 push button (Espresso / Steam)
10 On- / off button (ON / OFF)
11 Status indicator lamp (red)
12 Warming plate / cup tray
13 Filter insert for 1 cup
14 Filter insert for 2 cups
15 Filter holder
16 Filter safeguard
17 Measuring spoon / tamper (1 part, 2 functions)
Notes on Use
Placement
• Place the appliance on a stable and level surface.
• Due to rising heat and vapours do not operate the
appliance under wall cabinets.
• Do not place the appliance in close proximity to a
gas or electric stove or any other heat source.
Push Button
(9)
This control is a push-button switch with the following
functions when pressed or not pressed:
Push Button Disengaged Engaged
9
(Espresso)
(Steam)
Rotary Switch (3)
Left
Center
Right
Brew espresso Off Steam
Electric Connection
1. Ensure that your mains power corresponds with the
specications of the appliance. The specications
are printed on the type label.
2. Check the push button settings! The
push-button switch must not be pressed, and the
rotary switch must be at the center position.
3. Connect the mains cable to a properly installed and
earthed wall outlet.
On / Off
• Press the on / off button (10) briey to switch the ap-
pliance on. The status indicator lamp (11) lights up.
The appliance starts heating up. The warming plate
(12) heats up.
• The Indicator lamp (8) lights up as soon as the nec-
essary brewing temperature is reached.
NOTE:
The indicator lamp (8) turns on and off during oper-
ation. This is normal and indicates that the temper-
ature is thermostat-controlled and maintained.
• In order to switch the appliance off, press and hold
the on / off button (10) for 4 seconds. Then discon-
nect the mains plug from the socket.
European Regulations on Energy Saving
NOTE:
The European Directive 2009/125/EC (Ecodesign
Directive) incorporates measurements for energy
saving.
The following applies to coffee makers: The keep-
warm period is limited to max. 30 minutes after which
the appliance turns off automatically.
You benet from better safety and lower energy
consumption.
Operation
WARNING: Important!
Before use, always check the button settings! Before
you connect the appliance to a correctly installed
grounded socket, the
push-button switch must
not be pressed, and the rotary switch must be at the
position!
Attach / Detach Filter Holder
• Hold the handle at the left edge of the appliance to
attach the lter holder (see Fig. B on page 3). In-
sert the three guide tabs in the group head recess-
es. With the handle pull the lter holder to the right
hand side to the middle of the appliance. Ensure
that the lter holder is well secured in the group
head.
• Pull the lter holder to the left to detach from the
group head.
WARNING: Danger of burns!
After brewing the metal parts of lter holder and
lter insert are hot.
Inserting the Drip Tray / Drip Tray Grid
• Slide the drip tray for the residual water (6) into the
compartment (5).
• Place the drip tray grid (7) onto the compartment
as a cover. The recessed edge must face the appli-
ance housing.