User`s manual

D. ADJUSTING THE LAMINATOR (PRO-L ONLY)
If using Pro-L and applying the PolyGuard overlaminate, you may find that the
individual polyester chips from the overlaminate roll may sometimes be slightly
off-center when applied to a card. To center the vertical placement of these chips
across the card width, a simple mechanical adjustment can be made. This
adjustment is described below. To center the horizontal placement of these chips
along the card length, refer to Section 6-D for instructions on using the printer
driverÕs Calibrate option.
1. If the PolyGuard chips are being applied too closely to, or overlapping, a cardÕs
top or bottom edge (as the card travels through the printer), the laminatorÕs
Card Guide Rail should be adjusted. To do this, simply loosen the two screws
which fasten the Card Guide Rail to the printerÕs main chassis.
2. If the PolyGuard chip is being placed more toward a cardÕs top edge (as
shown), move the Card Guide Rail slightly toward the rear of the printer
(opposite the direction you would like the chip to move).
62 Section 8: Mechanical Adjustments
Pro/Pro-L Card Printer UserÕs Manual
Screws
Card
Guide Rail
Card Flipping
Mechanism
510301_pro_proL 11/24/98 12:03 PM Page 62