User`s manual

58 Section 8: Mechanical Adjustments
Pro/Pro-L Card Printer UserÕs Manual
1. Open the Card Hopper Door located on the right-hand side of the printerÕs
exterior by grasping the top of the door and pulling straight down. Allow the
door to swing completely open.
2. As you are looking straight into the Card Hopper, locate the left Card Input
Guide and loosen the two screws which fasten it to the back plate of the Card
Hopper.
3. Once these two screws have been loosened, it is possible to move the left Card
Input Guide slightly to the right or to the left. Insert the stack of cards.
4. Adjust the left Card Input Guide so it rests flush against the side of the card
stack, and re-tighten the two screws loosened in the previous steps. Adjustment
to the left Card Input Guide is now complete. If using Pro-L and the cards
being inserted are 2.3Ó (58mm) or wider, refer to Part B of this section. If using
Pro, note that cards cannot be wider than 2.13Ó (54mm).
B. ADJUSTING THE INTERNAL CARD GUIDES (PRO-L ONLY)
Two Internal Card Guides reside inside the Pro-L. These Internal Card Guides are
also adjustable to accommodate varying card widths. Although these card guides
are spring-loaded and will automatically adjust to slight card width variations, a
manual adjustment must be made in order for the printer to accept cards 2.3Ó
(58mm) or wider. Please refer to the following steps to adjust both of Pro-LÕs
Internal Card Guides:
1. Open both Top Covers of the printer by pressing the Cover Release Buttons.
Allow the covers to swing up and open.
2. Remove the ribbon and overlaminate rolls from the printer.
Drive Rollers
Internal
Card Guides
Card Guide Screws
Card Guide
Mounting Screws
510301_pro_proL 11/24/98 12:03 PM Page 58