User`s manual

30 Section 5: Card Laminating with Pro-L
Pro/Pro-L Card Printer UserÕs Manual
5. Place the take-up end of the roll in between the two black Lamination Drive
Hubs located on the far left-hand side of the printerÕs interior. Load the take-up
end of the roll just as you loaded the supply end in step 4. When loaded
properly, the overlaminate material should feed underneath both ends of the
overlaminate roll.
6. Close the cover. When you start to print, the Lamination Drive Hubs will
automatically engage the overlaminate core notches.
IMPORTANT! Do not reverse the overlaminate roll. Damage may occur to the lamination roller!
Supply Roll
Take-up Roll
510301_pro_proL 11/24/98 12:03 PM Page 30