User`s manual

Getting Started

Section 3: Getting Started 13

A. CHOOSING A GOOD LOCATION

Place the unit in a location with adequate air circulation to prevent internal heat

build up.

1. Use the dimensions specified in Section 10 as a guideline for the minimum

clearances to the unit.

NOTE:

Allow for adequate clearance above the unit to accommodate the height of the unit with its

cover open.

2. Do not install unit (a) near heat sources such as radiators or air ducts, or (b) in a

place subject to direct sun-light, excessive dust, mechanical vibration or shock.

B. ABOUT MOISTURE CONDENSATION

If the unit is brought directly from a cold to a warm location, or is placed in a very

damp room, moisture may condense inside the unit. Should this occur, print

quality may not be optimum. Leave the unit turned OFF in a warm, dry room for

several hours before using. This will allow the moisture to evaporate.

C. UNPACKING AND INSPECTION

While unpacking your printer, inspect the carton to ensure that no damage has

occurred during shipping. Make sure that all supplied accessories are included

with your unit. The following items should be included with your printer:

510301_pro_proL 11/24/98 12:03 PM Page 13