Specifications

73
Rollers
Rollers cut, gouged, ripped, blistered, bubbled Replace
Erratic Temperature Fluctuation Clean slip ring
Rollers cold when laminating Slow down motor
Insufficient edge seal Roller pressure
Wrinkling film Re-align towers, Add small amount of tension
Will not stop heating Unplug+ Contact technical support
Will not heat Contact technical support
Motor
Erratic speed, low Set too slow,
Erratic speed, mid, Contact tech support
Erratic speed, All Reduce mandrel tension, contact tech support
Will not run Check switch, dial, and fuses
Noise Gear noise is acceptable if it gets worse replace
The motor is the major source of noise
Noise / runs at minimum Contact Tech support
Temperature
Erratic Temperature Fluctuation Clean slip ring
Will not heat beyond “X” temperature Contact Tech support
Will not stop heating Unplug+ Contact technical support
Will not heat Contact technical support
Not enough heat Slow motor down
Display
Erratic temperature Fluctuation Clean slip ring
Display shows –1 Shorted signal from sensor
Display shows 1 Open signal from sensor
Display shows 440 degrees+ Shorted signal
Display shows nothing Turn on heat
Display shows “Bat” Incorrect voltage, unplug, contact tech support
Shows temperature much different than set point Allow machine to sit idle if it continues to rise
unplug the machine, contact tech support
Other
No function Check fuses and breakers – plug in
Switch works – light does not light Replace
Motor drive chain makes noise Misaligned sprockets – loose chain
Mandrels do not hold film from slipping Wrong mandrel / broken clip