Specifications

Startup:

After any service is performed on the machine or on the initial setup after

shipping.

Reveiw the following, BEFORE YOU FIRST PLUG IN THE MACHINE!

You MUST follow this procedure in this order. Use caution, you can burn

yourself easily on the laminating rollers it is advisable to use leather gloves for a

preliminary heat check of the rollers.

1. Turn all switches to off.

2. Plug the laminator in. Do not leave the laminator plugged in for more

than 3 minutes. DO NOT Leave the machine unattended during this

startup procedure without unplugging it!!!

3. Feel the rollers – top and bottom for a minute or so to see if they are

warming up, if they do, immediately unplug the machine and contact

tech support. (406-363-6145). Do not plug the machine back in, lock it

out if necessary. If they do not heat, continue to 4.

4. Turn the temperature control to its minimum setting (full

counterclockwise)

5. Turn on the heat / power switch

6. Watch the temperature display and make sure that it does not gain

temperature. Also feel both bottom and top rollers making sure that they

are not heating (if the room is rather cold the laminator may heat but

certainly not over 80 degrees). If the laminator heats beyond this point or

room temperature, immediately unplug the machine and contact tech

support. (406-363-6145). Do not plug the machine back in, lock it out if

necessary.- your temperature control may need to be replaced. if your

machine does not heat, continue to 7.

7. If only one roller heats, immediately unplug the machine and contact

tech support. (406-363-6145). Do not plug the machine back in, lock it

out if necessary. If neither roller heats, continue to 8.

8. Turn the temperature control to your normal operating temperature or

250 degrees and feel the rollers to make sure they are warming equally

(don’t burn yourself yet). If they are warming watch the machine until it

is heated to its operating temperature make sure that it stops heating at

the correct setting.

9. If you have reached this step without any errors, you are now ready to

laminate, your laminator can regulate its own temperature.