Specifications

30
Standard Towers w/o Slitters
These towers will be included with the hardware pack they do not have a
particular orientation (unidirectional)
4. Install towers on the left and right side using two 5/16 x ½” long, hex head
bolts each. These towers are ambidextrous and bidirectional, they cannot
be installed backward.
5. Tighten bolts snug (do not over tighten).
Lower towers w/o Stand
Your machine is available in two different configurations.
A. Without a stand, your towers will have to be installed on the laminator
below the feed tray.
B. With a stand, your towers should already be installed
Lower tower installation on the machine is similar to the tower installation for the
standard upper towers (without slitters).
Lower machine tower, viewed from left side.