Specifications

MOUNTING THE LAMINATOR

Set the stand in position on a flat level surface.

Using 2-3 people carefully the laminator on top of the stand, align the inside of

the stand with the inside of the panel that sits on it, align the front of the stand

with the front of the panel. Install the ¼-20 hex head screws with their respective

washers through the holes in the top rail. DO NOT tighten these screws.

The screw bosses on the bottom of the machine should drop into the pockets on

the top stand rail and there should be no space left between the top rail on the

stand and the bottom of the machine. Since the components of the stand have not

been tightened, it may be necessary to forcefully align each screw pocket with

each screw boss.