User Manual

English

USB Cable Clamp

When using a USB device, attach a USB cable clamp to the USB interface to

prevent the USB cable from being disconnected.

1. Attaching the USB Cable Clamp

Note: Watch your fingers. The edge of the clip is sharp.

WARNING

RECOMMENDATION FOR RESTRICTED AREAS

• Verify the power, input, and output (I/O) wiring are in accordance with

Class I, Division 2 wiring methods.

• Substitution of any component may impair suitability for Class I, Division 2.

• Confirm that the USB cable has been fixed with the USB cable clamp

before using the USB interface.

• Remove power before attaching or detaching any connectors to or from the

unit.

Failure to follow these instructions can result in death, serious injury,

or equipment damage.

Step Action

1 Mount the clip to the USB mark connector shell so that it

overlaps. The clip matches the 27 to 43.5mm [1.06 to 1.71 inch]

length of the USB connector.

2 Align the clip and the USB cable connector shell. Adjust the

position of the holes where the clip is attached. To ensure stability,

select the clip-hole position that is closest to the base of the

connector shell.

27 to 43.5mm

[1.06 to 1.71 in.]

Pass the tie

through here.