Owner's manual

6
1) Attach one screw to the Display’s rear
side. Use a torque of 0.5 N•m to 0.6 N•m (4.4
lb-in to 5.3 lb-in).
2) Attach the Conversion Adapter to the
Display.
3) Slide the Conversion Adapter in the
direction of the arrow so the Conversion
Adapter is hooked by the screw from step 1.
4) Fix the Conversion Adapter in place with
another screw. Use a torque of 0.5 N•m to 0.6
N•m (4.4 lb-in to 5.3 lb-in).
• When attaching the Conversion
Adapter to the Display, be careful with
the attachment position.
• Attach the Conversion Adapter to a
stable surface. Do not leave the
Conversion Adapter hanging by its
cord.
• Be careful with wire placement.
Overlapping cords may cause noise.
• Make sure the Conversion Adapter is
placed inside the edges of the Display.
Correct
Incorrect
• Do not place the Conversion Adapter
over the slits.
Correct
Incorrect
Rear face of Display
Rear face of Display
Rear face of Display
Rear face of Display