Owner's manual

2
Corresponding Units
General Specifications
 General Specifications
 Electrical Specifications
 Environmental Specifications
Model Conditions Remarks
GP4000 Series
(except GP-4100 Series
or GP-4*01TM)
Project file from GP-Pro EX
Ver3.00 or later (same
version as the Transfer Tool)
is transferred to the Display.
For information on supported
models including types and
specifications, refer to the
corresponding hardware
manual for your Display or
refer to the Pro-face Home
Page.
URL
http://www.pro-face.com/
Connector Type
Serial I/F D-Sub 9 pin (plug)
USB I/F Type A (plug), USB 2.0 Full Speed
Power
Supply
Rated Input Voltage 5 Vdc (Powered from USB bus)
Input Voltage Limits 4.75...5.25 Vdc
Power Consumption 0.75 W or less
Physical Environment
Surrounding Air Operating
Temperature
0...55 °C (32...131 °F)
Storage Temperature -20...60 °C (-4...140 °F)
Surrounding Air and Storage
Humidity
10...90 % RH (Non condensing, wet bulb
temperature 39 °C [102.2 °F] or less)
Dust 0.1 mg/m
3
(10
-7
oz/ft
3
) or less (non-conductive levels)
Pollution Degree For use in Pollution Degree 2 environment
Atmospheric Pressure
(Operating Altitude)
800...1114 hPa (2000 m [6561 ft] or lower)
Mechanical
Environment
Vibration Resistance
IEC/EN 61131-2 compliant
5...9 Hz Single amplitude 3.5 mm (0.14 in.)
9...150 Hz Fixed acceleration: 9.8 m/s
2
X, Y, Z directions for 10 cycles (100 min.)
Concussion Resistance
IEC/EN 61131-2 compliant
(147 m/s
2
, X, Y, Z directions for 3 times)